Edge-Core ECS4620-28P Cli Reference Manual page 728

Chapter 24
| Multicast Filtering Commands
MVR for IPv4
mvr
Table 137: Multicast VLAN Registration for IPv4 Commands
Command
mvr robustness-value
mvr source-port-mode
dynamic
mvr upstream-source-ip
mvr vlan
mvr immediate-leave
mvr type
mvr vlan group
clear mrv groups dynamic
clear mrv statistics
show mvr
show mvr
associated-profile
show mvr interface
show mvr members
show mvr profile
show mvr statistics
This command enables Multicast VLAN Registration (MVR) globally on the switch.
Use the no form of this command to globally disable MVR.
Syntax
[no] mvr
Default Setting
Disabled
Command Mode
Global Configuration
Function
Configures the expected packet loss, and thereby the
number of times to generate report and group-specific
queries
Configures the switch to only forward multicast streams
which the source port has dynamically joined
Configures the source IP address assigned to all control
packets sent upstream
Specifies the VLAN through which MVR multicast data is
received
Enables immediate leave capability
Configures an interface as an MVR receiver or source port
Statically binds a multicast group to a port
Clears multicast group information dynamically learned
through MVR
Clears MRV statistics
Shows information about MVR domain settings, including
MVR operational status, the multicast VLAN, the current
number of group addresses, and the upstream source IP
address
Shows the profiles bound the specified domain
Shows MVR settings for interfaces attached to the MVR
VLAN
Shows information about the current number of entries in
the forwarding database, or detailed information about a
specific multicast address
Shows all configured MVR profiles
Shows MVR protocol statistics for the specified interface
– 728 –
(Continued)
Mode
GC
GC
GC
GC
IC
IC
IC
PE
PE
PE
PE
PE
PE
PE
PE