Edge-Core ECS4620-28P Cli Reference Manual page 862

Chapter 27
| OAM Commands
efm oam
efm oam
critical-link-event
This command enables OAM functions on the specified port. Use the no form to
disable this function.
Syntax
[no] efm oam
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
◆
If the remote device also supports OAM, both exchange Information OAMPDUs
to establish an OAM link.
◆
Not all CPEs support OAM functions, and OAM is therefore disabled by default.
If the CPE attached to a port supports OAM, then this functionality must first be
enabled by the efm oam command to gain access to other remote
configuration functions.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam
Console(config-if)#
This command enables reporting of critical event or dying gasp. Use the no form to
disable this function.
Syntax
[no] efm oam critical-link-event {critical-event | dying-gasp}
critical-event - If a critical event occurs, the local OAM entity (this switch)
indicates this to its peer by setting the appropriate flag in the next
OAMPDU to be sent and stores this information in its OAM event log.
dying-gasp - If an unrecoverable condition occurs, the local OAM entity
indicates this by immediately sending a trap message.
Default Setting
Enabled
Command Mode
Interface Configuration
– 862 –