Edge-Core ECS4620-28P Cli Reference Manual page 561

Example
Console(config-erps)#meg-level 0
Console(config-erps)#
Related Commands
ethernet cfm domain (825)
ethernet cfm mep (830)
mep-monitor
This command specifies the CFM MEPs used to monitor the link on a ring node. Use
the no form to restore the default setting.
Syntax
mep-monitor {east | west} mep mpid
Default Setting
None
Command Mode
ERPS Configuration
Command Usage
◆
If this command is used to monitor the link status of an ERPS node with CFM
continuity check messages, then the MEG level set by the
must match the authorized maintenance level of the CFM domain to which the
specified MEP belongs.
◆
To ensure complete monitoring of a ring node, use the mep-monitor
command to specify the CFM MEPs used to monitor both the east and west
ports of the ring node.
◆
If CFM determines that a MEP node which has been configured to monitor a
ring port with this command has gone down, this information is passed to
ERPS, which in turn processes it as a ring node failure. For more information on
how ERPS recovers from a node failure, refer to "Ethernet Ring Protection
Switching" in the Web Management Guide.
Example
Console(config-erps)#mep-monitor east mep 1
Console(config-erps)#
east - Connects to next ring node to the east.
west - Connects to next ring node to the west.
mpid – Maintenance end point identifier. (Range: 1-8191)
– 561 –
Chapter 20
| ERPS Commands
meg-level command