Table 158: Igmp Proxy Commands - Edge-Core ECS4620-28P Cli Reference Manual

MLD Proxy Routing
ipv6 mld proxy
Querier
Joined Groups :
Static Groups :
FFEE::101
Console#
This section describes commands used to configure MLD Proxy Routing on the
switch.

Table 158: IGMP Proxy Commands

Command
ipv6 mld proxy
ipv6 mld proxy unsolicited-
report-interval
show ipv6 mld interface
To enable MLD proxy service, follow these steps:
1.
Use the ipv6 multicast-routing
the router.
2.
Use the ipv6 mld proxy
interface that is attached to an upstream multicast router.
3.
Use the ipv6 mld command to enable MLD on the downstream interfaces from
which to forward MLD membership reports.
4.
Optional – Use the ipv6 mld proxy unsolicited-report-interval
indicate how often the system will send unsolicited reports to the upstream
router.
This command enables MLD proxy service for multicast routing, forwarding MLD
membership information monitored on downstream interfaces onto the upstream
interface in a summarized report. Use the no form to disable proxy service.
Syntax
[no] ipv6 mld proxy
Default Setting
Disabled
Chapter 24
: FE80::200:E8FF:FE93:82A0
Function
Enables MLD proxy service for multicast routing
Specifies how often the upstream interface should
transmit unsolicited IGMP reports
Displays multicast information for the specified interface
command to enable IP multicasting globally on
command to enable MLD proxy on the upstream
– 789 –
| Multicast Filtering Commands
MLD Proxy Routing
Mode
IC
IC
PE
command to