Edge-Core ECS4620-28P Cli Reference Manual page 490

Chapter 15
| Congestion Control Commands
Automatic Traffic Control Commands
auto-traffic-control
release-timer
Command Usage
After the apply timer expires, a control action may be triggered as specified by the
auto-traffic-control action
snmp-server enable port-traps atc broadcast-control-apply
server enable port-traps atc multicast-control-apply
Example
This example sets the apply timer to 200 seconds for all ports.
Console(config)#auto-traffic-control broadcast apply-timer 200
Console(config)#
This command sets the time at which to release the control response after ingress
traffic has fallen beneath the lower threshold. Use the no form to restore the
default setting.
Syntax
auto-traffic-control {broadcast | multicast} release-timer seconds
no auto-traffic-control {broadcast | multicast} release-timer
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
seconds - The time at which to release the control response after ingress
traffic has fallen beneath the lower threshold. (Range: 5-900 seconds)
Default Setting
900 seconds
Command Mode
Global Configuration
Command Usage
This command sets the delay after which the control response can be terminated.
The auto-traffic-control auto-control-release
disable the automatic release of a control response of rate-limiting. To re-enable a
port which has been shut down by automatic traffic control, you must manually re-
enable the port using the
Example
This example sets the release timer to 800 seconds for all ports.
Console(config)#auto-traffic-control broadcast release-timer 800
Console(config)#
command and a trap message sent as specified by the
command must be used to enable or
auto-traffic-control control-release
– 490 –
command or snmp-
command.
command.