Edge-Core ECS4620-28P Cli Reference Manual page 926

Chapter 30
| IP Interface Commands
IPv6 Interface
ipv6 address eui-64
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled
Link-local address:
fe80::7272:cfff:fe83:3466%1/64
Global unicast address(es):
2001:db8:2222:7272::72/96, subnet is 2001:db8:2222:7272::/96
Joined group address(es):
ff02::1:ff00:72
ff02::1:ff83:3466
ff02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 3.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised router lifetime is 1800 seconds
Console#
Related Commands
ipv6 address eui-64 (926)
show ipv6 interface (932)
ip address (908)
This command configures an IPv6 address for an interface using an EUI-64 interface
ID in the low order 64 bits and enables IPv6 on the interface. Use the no form
without any arguments to remove all manually configured IPv6 addresses from the
interface. Use the no form with a specific address to remove it from the interface.
Syntax
ipv6 address ipv6-prefix/prefix-length eui-64
no ipv6 address [ipv6-prefix/prefix-length eui-64]
ipv6-prefix - The IPv6 network portion of the address assigned to the
interface.
prefix-length - A decimal value indicating how many contiguous bits (from
the left) of the address comprise the prefix (i.e., the network portion of the
address).
Default Setting
No IPv6 addresses are defined
Command Mode
Interface Configuration (VLAN)
Command Usage
◆
The prefix must be formatted according to RFC 2373 "IPv6 Addressing
Architecture, " using 8 colon-separated 16-bit hexadecimal values. One double
– 926 –