Table 107: Commands For Configuring Vlan Interfaces - Edge-Core ECS4620-28P Cli Reference Manual

Configuring VLAN Interfaces
Note: Ports can only be added to an RSPAN VLAN using the commands described
under "RSPAN Mirroring
Default Setting
By default only VLAN 1 exists and is active.
Command Mode
VLAN Database Configuration
Command Usage
◆
no vlan vlan-id deletes the VLAN.
◆
no vlan vlan-id name removes the VLAN name.
◆
no vlan vlan-id state returns the VLAN to the default state (i.e., active).
◆
You can configure up to 4094 VLANs on the switch.
Example
The following example adds a VLAN, using VLAN ID 105 and name RD5. The VLAN is
activated by default.
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
Related Commands
show vlan (601)

Table 107: Commands for Configuring VLAN Interfaces

Command
interface vlan
switchport acceptable-
frame-types
switchport allowed vlan
switchport forbidden vlan
switchport gvrp
switchport ingress-filtering
switchport mode
switchport native vlan
Commands".
Function
Enters interface configuration mode for a specified VLAN
Configures frame types to be accepted by an interface
Configures the VLANs associated with an interface
Configures forbidden VLANs for an interface
Enables GVRP for an interface
Enables ingress filtering on an interface
Configures VLAN membership mode for an interface
Configures the PVID (native VLAN) of an interface
– 593 –
Chapter 21
| VLAN Commands
Configuring VLAN Interfaces
Mode
IC
IC
IC
IC
IC
IC
IC
IC