Table 156: Mld Commands (Layer 3) - Edge-Core ECS4620-28P Cli Reference Manual

Chapter 24
| Multicast Filtering Commands
MLD (Layer 3)
ip igmp proxy
unsolicited-report-
interval
MLD (Layer 3)
This command specifies how often the upstream interface should transmit
unsolicited IGMP reports. Use the no form to restore the default value.
Syntax
ip igmp proxy unsolicited-report-interval seconds
no ip igmp proxy unsolicited-report-interval
seconds - The interval at which to issue unsolicited reports.
(Range: 1-65535 seconds)
Default Setting
400 seconds
Command Mode
Interface Configuration (VLAN)
Example
The following example sets the interval for sending unsolicited IGMP reports to 5
seconds.
switch(config)#interface vlan
switch(config-if)#ip igmp proxy unsolicited-report-interval 5
switch(config)#
This section describes commands used to configure Layer 3 Multicast Listener
Discovery (MLD) on the switch.

Table 156: MLD Commands (Layer 3)

Command
ipv6 mld
ipv6 mld last-member-
query-response-interval
ipv6 mld max-resp-interval
ipv6 mld query-interval
ipv6 mld robustval
ipv6 mld static-group
ipv6 mld version
clear ipv6 mld group
show ipv6 mld groups
show ip igmp interface
Function
Enables MLD for the specified interface
Configures the frequency at which to send query messages
in response to receiving a leave message
Configures the maximum host response time
Configures frequency for sending host query messages
Configures the expected packet loss
Statically binds multicast groups to a VLAN interface
Configures MLD version used on an interface
Deletes entries from the MLD cache
Displays information for MLD groups
Displays multicast information for an interface
– 780 –
Mode
IC
IC
IC
IC
IC
IC
IC
PE
PE
PE