Configuration With Static Assembly - WAGO 750-306 Technical Description

52 • Fieldbus Coupler/Controller
Fieldbus Coupler 750-306
2. DIP switches 7 and 8 are used to set the desired baud rate.
1
2
3
4
5
6
7
8
Fig. 3-11: Example: Setting the baud
rate 250 kBaud (DIP 7 = ON) of the
station with MAC ID 1.
3. Then switch on the Coupler supply voltage.

3.1.7.3 Configuration with Static Assembly

In this example, the software WAGO NETCON is used for the configuration.
The node in the example consists of the following I/O modules:
Fig. 3-12: Example for a fieldbus node
1. Starting Software and EDS file load
1. Start the configuration software WAGO NETCON.
2. Load an EDS file for the fieldbus Coupler in WAGO NETCON, i. e.
ON
1
DI DI DI DI
402 402
"4.EDS".
For this click on "File/ Copy EDS" and choose the EDS-file to load.
Note
You can download the EDS files for the fieldbus Coupler from the Inter-
net under: www.wago.com.
Upon downloading the EDS file into WAGO NETCON, you can create a
new project and start configuring your network.
Baud rate
*)
125 kBaud
250 kBaud
500 kBaud
g012541x
not allowed
*)
Presetting
2 3 4 5 6
DODO DODO AI AI
DODO
516
516 516 467
DIP7 DIP8
OFF OFF
ON OFF
OFF ON
ON ON
7 8
AO AO
550 600
WAGO-I/O-SYSTEM 750
g012552x
DeviceNet