WAGO 750-306 Technical Description page 28

28 • The WAGO-I/O-SYSTEM 750
Power Supply
Warning
In the case of power supply modules with fuse holders, only fuses with a
maximal dissipation of 1.6 W (IEC 127) must be used.
For UL approved systems only use UL approved fuses.
In order to insert or change a fuse, or to switch off the voltage in succeeding
bus modules, the fuse holder may be pulled out. In order to do this, use a
screwdriver for example, to reach into one of the slits (one on both sides) and
pull out the holder.
Fig. 2-15: Removing the fuse carrier
Lifting the cover to the side opens the fuse carrier.
Fig. 2-16: Opening the fuse carrier
Fig. 2-17: Change fuse
After changing the fuse, the fuse carrier is pushed back into its original posi-
tion.
p0xxx05x
p0xxx03x
p0xxx04x
WAGO-I/O-SYSTEM 750
DeviceNet