Configuration / Parametering With The Object Model - WAGO 750-306 Technical Description

116 • DeviceNet

Configuration / Parametering with the Object Model

Input 2 (I/O Assembly Instance 8):
The digital input data image is transmitted to the master via the corresponding
I/O message connection. The data length is equivalent to the number of digital
input data and is rounded up to full bytes.
Input 3 (I/O Assembly Instance 9):
The analog input data image is transmitted to the master via the corresponding
I/O message connection. The data length is equivalent to the number of analog
input data in bytes.
5.6 Configuration / Parametering with the Object Model
5.6.1 EDS Files
In DeviceNet, the capacity characteristics of the devices are documented by
the manufacturers in the form of an EDS file (Electronic Data Sheet) and
made available to the user.
Architecture, contents and coding of the EDS files are standardized which
permits design and configuration with devices of different manufacturers.
EDS file for I/O module 750-806
*
The EDS file is read by the configuration software and corresponding settings
transmitted. For required entries and handling steps for this purpose, please re-
fer to the software user manuals.
Further information
ODVA informs about the EDS files of all listed manufacturers.
http://www.odva.org
EDS and symbol files to configure the I/O modules are available under the
order numberr 750-912 on a floppy disk or on the WAGO INTERNET
homepage.
http://www.wago.com
)
_1 indicates that this EDS file is valid for Controllers with firmware major version 1.
)
750-806_1.EDS *
WAGO-I/O-SYSTEM 750
DeviceNet