WAGO 750-306 Technical Description page 83

Note
To be able to access the Controller, ensure that the operating mode switch of
the Controller is set to the center or the top position.
5. Under "Online" click on the "Log-on" menu point to log into the Control-
6. If there is not a program in the Controller, a window appears asking
7. As soon as the program is loaded, you can start program via the "Online"
8. To terminate the online operation, return via the "Online" menu and click
3.2.6.2.2 Transmission via the Fieldbus
The field bus cable is the physical connection between the PC and the Con-
troller. It is necessary to have a suitable communication driver for data trans-
mission. This driver and how it is parametered is entered in
WAGO-I/O-PRO 32 in the "communication parameter" dialog.
Note
Transmission via the fieldbus is supported by UCMM. Here, for the down-
load of the PFC program, WAGO-I/O-PRO 32 counts as a subscriber.
1. Start the WAGO-I/O-PRO 32 software via 'Start/Programs' or by double
2. In the "Online" menu click on the "Communication parameters" menu
3. Click on the "New" button to define a driver in the "Communication pa-
4. Enter any name and mark the driver "Hilscher PA Interface standard" in
5. If necessary, change the entry accordingly in the center window of the dia-
WAGO-I/O-SYSTEM 750
DeviceNet
ler.
(The WAGO-I/O-PRO 32 server is active during online operation. The
communication parameters cannot be polled.)
whether or not the program is to be loaded.
Confirm with "Yes".
Subsequently the current program will be loaded.
menu, menu point "Start".
At the right-hand end of the status bar, the system signals "ONLINE
RUNNING"."
on the "Log-off" menu point.
clicking on the WAGO-I/O-PRO-32 symbol on your desk top.
point.
The "Communication parameters" dialog opens.
rameter" dialog
the selection window of the dialog.
Subsequently confirm with "OK".
log.
Feldbus-Koppler/-Controller • 83
Fieldbus Controller 750-806