3.2.2 Hardware
3.2.2.1 View
Fieldbus
connection
Series 231
(MCS)
DIP switch
for MAC ID
and baud rate
Configuration
and programming
interface
Fig. 3-20: Fieldbus Controller 750-806 DeviceNet
The fieldbus Controller is comprised of:
• Device supply with an internal system supply module as well as power
• Fieldbus interface with the bus connection
• DIP switch for baud rate and node ID
• Display elements (LEDs) for status display of the operation, the bus com-
• Configuration and programming interface and operating mode switch
• Electronics for communication with the I/O modules (internal bus) and the
WAGO-I/O-SYSTEM 750
DeviceNet
jumper contacts for the field supply via assembled I/O modules
munication, the operating voltages as well as for fault messages and diag-
nosis
fieldbus interface
Feldbus-Koppler/-Controller • 63
DeviceNet
01 02
OVERFL
A
C
MS
B
RUN
D
BUS OFF
24V 0V
NS
CONNECT
I/O
+
+
USR
Ñ
Ñ
operating
mode switch
flap
opened
Fieldbus Controller 750-806
Status
voltage supply
-Power jumper
contacts
-System
Data contacts
Supply
24V
0V
Supply via
power jumper
contacts
24V
0V
Power jumper
contacts
g080600e