Configuration Software; Starting-Up Devicenet Fieldbus Nodes; Connecting The Pc And Fieldbus Node; Setting The Mac Id And Baud Rate - WAGO 750-306 Technical Description

3.2.8 Configuration Software

To allow a connection between the PLC and the fieldbus devices, the interface
modules have to be configured with the individual station file.
To this effect, the scope of the WAGO-I/O-SYSTEM 758 includes the
WAGO NETCON software intended for design and configuration, start-up and
diagnosis.
Further configuration software of different manufacturers include, for in-
stance, RSNetWorx.

3.2.9 Starting-up DeviceNet Fieldbus Nodes

This chapter shows the step-by-step procedure for starting up a
WAGO DeviceNet fieldbus node.
Following this will be information for programming the PFC with WAGO-
I/O-PRO 32.
Attention
This description is given as an example and is limited to the execution of a
local start-up of an individual DeviceNet fieldbus node.
The procedure contains the following steps:

1. Connecting the PC and fieldbus node

2. Setting the MAC ID and baud rate

3. Configuration with static and dynamic Assembly
3.2.9.1 Connecting the PC and Fieldbus Node
1. Connect the assembled DeviceNet fieldbus node to the DeviceNet field-
2. Start your PC.
3.2.9.2 Setting the MAC ID and Baud Rate
1. Use the DIP switches 1...6 to set the desired node address (MAC ID). The
Fig. 3-30 Example: Setting the MAC
ID 4 (DIP 3 = ON).
WAGO-I/O-SYSTEM 750
DeviceNet
bus PCB in your PC via a fieldbus cable and start your PC.
The 24 V field bus supply is fed by an external fieldbus network power
supply over the connections V+, V- of the 5-pin fieldbus connector (MCS
Series 231).
binary significance of the individual DIP switches increases according to
the switch number.
g012443x
Feldbus-Koppler/-Controller • 87
Fieldbus Controller 750-806
DIP switch Value
1
0
2
2 1
2
3 2
2
4
3
2
5 4
2
6 5
2