WAGO 750-306 Technical Description page 127

5.6.2.1.8 Coupler configuration object (0x64):
Instance 0:
Attribute
ID
1
2
Instance 1:
Attribute
ID
1
2
3
4
5
6
7
8
9
10
11
12
13
WAGO-I/O-SYSTEM 750
DeviceNet
Configuration / Parametering with the Object Model
Used in Access Name
buscoupler rule
required get Revision
required get Max
instance
Used in Access Name
buscoupler rule
specific get/set Bk_Module
No
specific get/set Bk_TableNo USINT
specific get/set Bk_Register
No
specific get/set Bk_Data
specific get ProcessState
specific get DNS_i_Trm
nldia (**)
specific get CnfLen.
AnalogOut
specific get CnfLen.
AnalogInp
specific get CnfLen.
DigitalOut
specific get CnfLen.
DigitalInp
specific get/set BK_FAULT
_REACTIO
N
specific get/set BK_SEL_S
TORED_PO
LL_P_PAT
H
specific get/set BK_SEL_S
TORED_PO
LL_C_PAT
H
Data type Description
UINT Revision of the Identity Object,
Range 1-65535, class definition
upon which the implementation is
based.
UINT maximum instance number of an
object currently created in this
class level of device
Data Description
type
USINT module number: 0-Coupler, 1- first module,
2-2.module
table number: 0 ... 256; not all existing
USINT Register number: 0...255 for the Coupler
(0...63 for modules)
UINT Register data , Status
USINT Coupler status: 0x01 module communication
error, 0x08: module diagnostic , 0x80 fieldbus
error
UINT Module status, 0x8000 to decode a message,
High Byte (Bit14...8): channel number, Low
Byte (Bit7..0) Module number
UINT number of I/O Bits for analog output data
words
UINT number of I/O Bits for analog input data
words
UINT number of I/O Bits for digital output data bits
UINT number of I/O Bits for digital input data bits
USINT An enumerator used to specify fieldbus error
handling
0: stop local I/O cycles (default)
1: switch all outputs to 0
2: do nothing
3:switch all outputs to a predefined output
image
UINT Non volatile power up value for the polled I/O
produced connection path. The attribute is
used to hold an enumerator for the assembly
path and the class and instance for the modu-
les object (discrete input point...) paths.Write
only instance values that are available for
Couplers present module configuration. (e.g.
do not use analog input points if only digital
modules are fixed to the Coupler.
0: bad value, path value not visible
1: analog and digital output data
2: only digital output data
3: only analog output data
4:analog and digital input data,status
5: only digital input data plus status
6: only analog input data plus status
7: analog and digital input data
8: only digital input data
9: only analog input data
UINT Non volatile power up value for the polled I/O
consumed connection path. The attribute is
used to hold an enumerator for the assembly
path and the class and instance for modules
object (discrete input point ...) paths. Write
DeviceNet • 127
Value
0x01
0x01