ACS380 FW.book Page 60 Friday, May 4, 2018 4:18 PM
60 Program features
Drive configuration and programming
The drive control program is divided into two parts:
• firmware program
• application program
Application program
Function block
program
Standard block
library
The firmware program performs the main control functions, including speed, torque
and frequency control, drive logic (start/stop), I/O, feedback, communication and
protection functions. Firmware functions are configured and programmed with
parameters, and can be extended by application programming
Programming via parameters
Parameters configure all of the standard drive operations and can be set via
• the integrated panel, as described in chapter
• an external panel
• the Drive composer PC tool, as described in Drive composer PC tool user's
manual (3AUA0000094606 [English]), or
• the fieldbus interface, as described in chapters
embedded fieldbus interface (EFB)
adapter.
All parameter settings are stored automatically to the permanent memory of the drive.
However, if an external +24 V DC power supply is used for the drive control unit, it is
highly recommended to force a save by using parameter
manually
before powering down the control unit after any parameter changes have
been made.
If necessary, the default parameter values can be restored by parameter
Parameter
restore.
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Drive control program
Firmware
Speed control
Torque control
Frequency control
Drive logic
Parameter
I/O interface
interface
Fieldbus interface
Protections
Control panel
Fieldbus control through the
and
Fieldbus control through a fieldbus
M
96.07 Parameter save
96.06