Parameter Listing - ABB ACS380 Firmware Manual

ACS380 FW.book Page 115 Friday, May 4, 2018 4:18 PM

Parameter listing

No. Name/Value
01
01 Actual values
01.01 Motor speed used
-30000.00... 30000.00
rpm
01.02 Motor speed
estimated
-30000.00... 30000.00
rpm
01.03 Motor speed %
-1000.00... 1000.00%
01.04 Encoder 1 speed
filtered
-30000 ... 30000
01.06 Output frequency
-500.00...500.00 Hz
01.07 Motor current
0.00...30000.00
01.08 Motor current % of
motor nom
0.0...1000.0%
01.09 Motor current % of
drive nom
0.0...1000.0%
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Description
Basic signals for monitoring the drive.
All parameters in this group are read-only unless
otherwise noted.
Note: Values of these actual signals are filtered with the
filter time defined in group 46 Monitoring/scaling
The selection lists for parameters in other groups mean
the raw value of the actual signal instead. For example, if
a selection is "Output frequency" it does not point to the
value of parameter 01.06 Output frequency
value.
Measured or Estimated motor speed depending on the
type of feedback used in parameter 96.01 Motor feedback
selection. A filter time constant for this signal can be
defined by parameter 46.11 Filter time motor
Measured or estimated motor speed.
Estimated motor speed in rpm. A filter time constant for
this signal can be defined by parameter
motor speed.
Estimated motor speed.
Actual speed in percent of the motor synchronous speed.
The filter time constant can be adjusted by parameter
46.11 Filter time motor speed.
Motor speed.
Measured motor speed from Encoder 1. The filter time
constant can be adjusted by parameter
motor speed.
Estimated drive output frequency in Hz. A filter time
constant for this signal can be defined by parameter
Filter time output frequency.
Estimated output frequency.
Measured (absolute) motor current in A.
Motor current.
Motor current (drive output current) in percent of the
nominal motor current.
Motor current.
Motor current (drive output current) in percent of the
nominal drive current.
Motor current.
Parameters 115
Default
FbEq 16
settings.
but to the raw
-
speed.
See par.
46.01
-
46.11 Filter time
See par.
46.01
-
See par.
46.01
-
46.11 Filter time
1=1
-
46.12
See par.
46.02
-
See par.
46.05
-
1=1%
-
1=1%