Contents - ABB ACS380 Firmware Manual

ACS380 FW.book Page 355 Friday, May 4, 2018 4:18 PM
Additional parameter data

Contents

•

Terms and abbreviations
• Fieldbus addresses
• Parameter groups 1...9
• Parameter groups 10...99
Terms and abbreviations
Term
Actual signal
Analog src
Binary src
Data
FbEq32
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Definition
Signal measured or calculated by the drive. Usually can only be monitored
but not adjusted; some counter-type signals can however be reset.
Analog source: the parameter can be set to the value of another parameter
by choosing "Other", and selecting the source parameter from a list.
In addition to the "Other" selection, the parameter may offer other pre-
selected settings.
Binary source: the value of the parameter can be taken from a specific bit
in another parameter value ("Other"). Sometimes the value can be fixed to
0 (false) or 1 (true). In addition, the parameter may offer other pre-selected
settings.
Data parameter.
32-bit fieldbus equivalent: The scaling between the value shown on the
panel and the integer used in communication when a 32-bit value is
selected for transmission to an external system.
The corresponding 16-bit scalings are listed in chapter Parameters.
Additional parameter data
7
355