Target Audience - ABB ACS380 Firmware Manual

ACS380 FW.book Page 12 Friday, May 4, 2018 4:18 PM
12 Introduction to the manual

Target audience

The reader is expected to know the fundamentals of electricity, wiring, electrical
components and electrical schematic symbols.
The manual is written for readers worldwide. Both SI and imperial units are shown.
Purpose of the manual
This manual provided information for designing, commissioning, or operating the
drive system.
Contents of the manual
• Introduction to the manual (this chapter) describes the applicability, purpose and
content of the manual, and terms and conditions.
• Control panel
• Start-up, ID run and use
drive and perform the ID run, and descriptions of the main use cases.
• Control macros
with a connection diagram. Macros are pre-defined applications and saves the
user time when configuring the drive.
• Program features
• Parameters (page 111) describes the parameters used to program the drive.
• Additional parameter data
parameters.
• Fault tracing (page 389) lists the warning and fault messages with possible
causes and remedies.
• Fieldbus control through the embedded fieldbus interface (EFB)
describes the communication to and from a fieldbus network using the embedded
fieldbus interface of the drive.
• Fieldbus control through a fieldbus adapter
communication to and from a fieldbus network using an optional fieldbus module.
• Control chain diagrams
• Appendix A - ACS380 in crane applications
that are specific to the crane application. If required, these functions can be used
for other applications.
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
(page 17) introduces the internal control panel.
(page 23) contains instructions on how to start up the
(page 31) contains a short description of each macro together
(page 51) describes the program features and parameters.
(page 355) contains further information on the
(page 495) presents the reference chains of the drive.
(page 415)
(page 481) describes the
(page 511) describes the functions