At+Colp Connected Line Identification Presentation - SimCom SIM5350 Command Set

SIM5350 AT Command Set
Examples
AT+CLIR=?
+CLIR:(0-2)
OK
4.11

AT+COLP Connected line identification presentation

Description
This command refers to the GSM/UMTS supplementary service COLP(Connected Line
Identification Presentation) that enables a calling subscriber to get the connected line identity
(COL) of the called party after setting up a mobile originated call. The command enables or
disables the presentation of the COL at the TE. It has no effect on the execution of the
supplementary service COLR in the network.
When enabled (and called subscriber allows), +COLP:<number>,
[,<alpha>]] intermediate result code is returned from TA to TE before any +CR responses. It is
manufacturer specific if this response is used when normal voice call is established.
When the AT+COLP=1 is set, any data input immediately after the launching of "ATDXXX;" will
stop the execution of the ATD command, which may cancel the establishing of the call.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command
AT+COLP=?
Read Command
AT+COLP?
Write Command
AT+COLP =<n>
Defined values
<n>
Parameter sets/shows the result code presentation status in the TA:
SIM5350_ATC_V1.02
Responses
+COLP: (list of supported <n>s)
OK
Responses
+COLP: <n>,<m>
OK
ERROR
+CME ERROR: <err>
Responses
OK
ERROR
+CME ERROR: <err>
40
<type> [,<subaddr>, <satype>
6/9/2014