At+Cgerep Gprs Event Reporting - SimCom SIM5350 Command Set

SIM5350 AT Command Set
8.9

AT+CGEREP GPRS event reporting

Description
The write command enables or disables sending of unsolicited result codes,
TE in the case of certain events occurring in the Packet Domain MT or the network.
controls the processing of unsolicited result codes specified within this command.
the effect on buffered codes when
ERROR or +CME ERROR: is returned.
Read command returns the current
Test command returns the modes and buffer settings supported by the MT as compound values.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command
AT+CGEREP=?
Read Command
AT+CGEREP?
Write Command
AT+CGEREP=
<mode>[,<bfr>]
Defined values
<mode>
a numeric parameter
0 disables sending of URC, +CGEV. No codes are forwarded to the TE.
1 eables sending of URC, +CGEV. Forward them directly to the TE.
<bfr>
a numeric parameter
0 MT will not buffer any URC. 0 is default value if omitted, and it's the only supported setting.
+CGEV:
For network attachment, the following unsolicited result codes and the corresponding events are
defined:
▪ +CGEV: NW DETACH
The network has forced a PS detach. This implies that all active contexts have been deactivated.
These are not reported separately.
SIM5350_ATC_V1.02
<mode> 1 or 2 is entered. If a setting is not supported by the MT,
<mode> and buffer settings.
Responses
+CGEREP: (list of supported <mode>s),(list of supported <bfr>s)
OK
Responses
+CGEREP: <mode>,<bfr>
OK
Responses
OK
ERROR
+CME ERROR: <err>
121
"+CGEV" from MT to
<mode>
<bfr> controls
6/9/2014