SimCom SIM5350 Command Set page 33

SIM5350 AT Command Set
=<n>
AT+CLCC
Execution Command
AT+CLCC
Defined values
<n>
0 – Don't report a list of current calls of ME automatically when the current call status changes.
1 – Report a list of current calls of ME automatically when the current call status changes.
<idX>
Integer type, call identification number, this number can be used in +CHLD command operations.
<dir>
0 – mobile originated (MO) call
1 – mobile terminated (MT) call
<stat>
State of the call:
0 – active
1 – held
2 – dialing (MO call)
3 – alerting (MO call)
4 – incoming (MT call)
5 – waiting (MT call)
<mode>
bearer/teleservice:
0 – voice
1 – data
3 – voice followed by data, voice mode
4 – alternating voice/data, voice mode
6 – voice followed by data, data mode
7 – alternating voice/data, data mode
9 – unknown
<mpty>
0 – call is not one of multiparty (conference) call parties
1 – call is one of multiparty (conference) call parties
<number>
SIM5350_ATC_V1.02
OK
Responses
+CLCC:<id1>,<dir>,<stat>,<mode>,<mpty>[,<number>,<type>[,<
alpha>]][<CR><LF>
+CLCC:<id2>,<dir>,<stat>,<mode>,<mpty>[,<number>,<type>[,<
alpha>]]
[...]]
OK
ERROR
+CME ERROR: <err>
32
6/9/2014