At+Cgqreq Quality Of Service Profile (Requested) - SimCom SIM5350 Command Set

SIM5350 AT Command Set
+CGDCONT: (1-16),"IPV6",,,(0-2),(0-4)
OK
8.2

AT+CGQREQ Quality of service profile (requested)

Description
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends
an Activate PDP Context Request message to the network.. A special form of the set command
(AT+CGQREQ=<cid>)
undefined.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command
AT+CGQREQ=?
Read Command
AT+CGQREQ?
Write Command
AT+CGQREQ=<cid>
[,<precedence>
[,<delay>[,<reliability>
[,<peak> [,<mean>]]]]]
Execution Command
AT+CGQREQ
SIM5350_ATC_V1.02
causes the requested profile for context number
Responses
+CGQREQ: <PDP_type>, (list of supported <precedence>s), (list
of supported <delay>s), (list of supported <reliability>s) , (list of
supported <peak>s), (list of supported <mean>s) [<CR><LF>
+CGQREQ: <PDP_type>, (list of supported <precedence>s), (list
of supported <delay>s), (list of supported <reliability>s) , (list of
supported <peak>s), (list of supported <mean>s)
[...]]
OK
ERROR
Responses
+CGQREQ: [<cid>,
<peak>, <mean>[<CR><LF>
+CGQREQ: <cid>,
<mean>[...]]]
OK
ERROR
Responses
OK
ERROR
Responses
OK
ERROR
110
<precedence >, <delay>, <reliability>,
<precedence >, <delay>, <reliability.>, <peak>,
<cid> to become
6/9/2014