At+Cnmi New Message Indications To Te - SimCom SIM5350 Command Set

SIM5350 AT Command Set
(default is empty string);
e.g. "0,1,5,320-478,922"
<dcss>
String type; all different possible combinations of CBM data coding schemes (refer <dcs>) (default
is empty string); e.g. "0-3,5"
Examples
AT+CSCB=?
+CSCB: (0-1)
OK
AT+CSCB=0,"15-17,50,86",""
OK
7.9

AT+CNMI New message indications to TE

Description
This command is used to select the procedure how receiving of new messages from the network is
indicated to the TE when TE is active, e.g. DTR signal is ON. If TE is inactive (e.g. DTR signal is
OFF). If set <mt>＝2, <mt>＝3 or <ds>＝1, make sure <mode>＝1, otherwise it will return error.
SIM PIN References
YES 3GPP TS 27.005
Syntax
Test Command
AT+CNMI=?
Read Command
AT+CNMI?
Write Command
AT+CNMI=<mode>[,<mt>[,
<bm>[,<ds> [,<bfr>]]]]
Defined values
<mode>
SIM5350_ATC_V1.02
Responses
+CNMI: (list of supported <mode>s),(list of supported <mt>s),(list
of supported <bm>s),(list of supported <ds>s),(list of supported
<bfr>s)
OK
Responses
+CNMI: <mode>,<mt>,<bm>,<ds>,<bfr>
OK
Responses
OK
ERROR
+CMS ERROR: <err>
92
6/9/2014