Ate Enable Command Echo; Ath Disconnect Existing Call - SimCom SIM5350 Command Set

SIM5350 AT Command Set
3.3

ATE Enable command echo

Description
This command sets whether or not the TA echoes characters.
SIM PIN References
NO V.25ter
Syntax
Execution Command
ATE[<value>]
Defined values
<value>
0 DCE does not echo characters during command state and online command state.
1 DCE echoes characters during command state and online command state.
Examples
ATE1
OK
3.4

ATH Disconnect existing call

Description
This command is used to disconnect existing call. Before using
call, it must set AT+CVHU=0. Otherwise, ATH command will be ignored and "OK" response is
given only.
This command is also used to disconnect CSD or PS data call, and in this case it doesn't depend on
the value of AT+CVHU.
SIM PIN References
NO V.25ter
Syntax
Execution Command
ATH
Examples
SIM5350_ATC_V1.02
Responses
OK
ERROR
Responses
OK
14
ATH command to hang up a voice
6/9/2014