Oracle Acme Packet 6100 Hardware Installation Manual page 25

IN
OUT
Grounding Terminals
Power Supply
Redundancy
AC Power
AC Power Cords
Acme Packet 6100 Hardware Installation Guide
IN
OUT
System
Power
On Stby
Console Alarm USB
Stby Dis
Power Supply B
Figure 2 - 27. Acme Packet 6100 Dual DC Power Supplies and Grounding Posts
During normal operation, the Acme Packet 6100 is load-balanced and draws
power from both supplies. The two power supplies also provide hardware
redundancy. If a power supply fails, the Acme Packet 6100 can rely on only one
functional power supply to sustain normal operation. A malfunctioning power
supply must be removed and replaced as soon as possible. If the Acme Packet
6100 starts up with only one power supply, it will not generate an alarm.
The auto-sensing AC power supply is rated at 110-240 VAC, 50-60 Hz, and is
supplied with an IEC connector. The handle on the front panel of the power
supply is used to insert and remove the power supply from the chassis. The
grey locking handle, when moved from right to left, unlocks the power supply
from the chassis.
Figure 2 - 28. Acme Packet 6100 AC Power Supply
Acme Packet ships each AC-powered Acme Packet 6100 with one 2 meter, 3-
conductor 18 AWG power cord for each power supply. The power cord, fitted
LINK ACT
Mgmt 0 Mgmt 1 Mgmt 2
IN
OUT
Power Supply A
LINK ACT
PWR H/S
IN
OUT
Handle to 
Remove/Insert
Power Supply
Locking Tab to
Lock/Unlock
Power Supply to
Acme Packet
6100
17