Battery Warning; Esd Safety - Oracle Acme Packet 6100 Hardware Installation Manual

Precautions

Battery Warning

Caution:
Caution:

ESD Safety

2
Note the locations of the System Power switch on the Acme Packet 6100
•
and the location of the emergency power-off switch for the room where the
Acme Packet 6100 is located.
If an electrical accident occurs, remove power from the system
•
immediately by unplugging the chassis.
Always disconnect the power from the system when removing a Acme
•
Packet 6100 from its rack.
When disconnecting power:
•
• Turn the System Power switch to the Stby position.
• Disconnect the circuit breaker at the rack.
• Unplug or unscrew the power cords from the power supplies.
Use grounded AC power cords that are plugged into grounded electrical
•
outlets.
Never use extension cords to power a Acme Packet 6100.
•
Ensure that the installation facilities have proper grounding systems and
•
include a grounded rack structure or local grounding bus bar.
When installing the Acme Packet 6100 in an equipment rack, always make
•
the ground connection first and disconnect it last upon un installation.
Use shielded Category 5e or 6, RJ45 cables for all 10/100/1000 Ethernet
•
connections to protect the Acme Packet 6100 from potential damage.
To avoid making a complete circuit (which causes electrical shock), use
•
only one hand when working with powered-on electrical equipment.
Use caution when using electrically conductive tools around the Acme
•
Packet 6100.
Remove jewelry before working on the Acme Packet 6100.
•
RISK OF EXPLOSION IF BATTERY IS REPLACED BY
AN INCORRECT TYPE. DISPOSE OF USED BATTERY
ACCORDING TO THE INSTRUCTIONS.
Perchlorate Material — Special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
To protect the Acme Packet 6100 delicate electronic components from damage
from static electricity, always follow the appropriate ESD procedures and wear
Acme Packet 6100 Hardware Installation Guide