Changing Button Programming - Nortel Compact ICS 7.1 Coordinator Manual

160 / User Preferences
User Preferences programming is available under User Preferences
under the heading Terminals&Sets.

Changing button programming

Press ≠ at Button prgrming. The display shows the number of
buttons on the telephone (an example is shown in Displays at the end of this
section).
If the telephone has a CAP module, you can press CAP1 or KIM1 to see the
buttons on the module.
Press ' to move through all the buttons on the telephone. Refer
to ''Default button assignments'' on page 150 for button number mapping
for each type of Business Series Terminal and Norstar M-series telephones.
Use the display buttons to change the programming for a button. User
Preferences programming cannot change the buttons that are used by lines,
intercom, and the handsfree feature, which are assigned by the system
administrator. Refer to the Compact ICS 7.1 Installer Guide for details.
The display buttons used in button programming
CANCL
Moves you out of a setting without making any changes to it.
CLR
Erases the button.
TEL#
Programs the button as an autodial number for an internal or an
external number. If it is an external autodial number, you have to
choose a line, line pool, or the routing table for the call to use.
CHANGE
Used when you are setting up an external autodial number. Press
CHANGE until you see the type of line or pool you want the number
to use.
FEATR
Press to store a feature code on the button.
FIND
Locates a specific button on a telephone by entering its number.
Button numbers are shown in the illustrations.
LIST
Takes you to a list of feature codes. Press ' to move
through the list and press OK when you see the feature you want to
program on the button.
Information about individual displays you may see is described at the end
of this section.
Compact ICS 7.1 System Coordinator Guide N0130955 01