Using Special Telephones; Direct-Dial; Changing The Direct-Dial Telephone Assignments - Nortel Compact ICS 7.1 Coordinator Manual

220 / Using System features

Using special telephones

Direct-dial

You can reach the direct-dial telephone by dialing a single digit. The
direct-dial telephone is usually in a central location, such as a attendant's
desk. It is usually the prime telephone or the central answering position
(CAP).
The direct-dial telephone can send up to 30 messages and can invoke
Services to activate the extra-dial telephone.
You cannot forward calls to a direct-dial telephone that is outside your
Norstar system. See ''Making changes to Call Forward No Answer'' on
page 35.
Note: ISDN terminals cannot use the Direct-Dial digit to reach a Direct-
Dial set.

Changing the direct-dial telephone assignments

Your installer or customer service representative sets up the direct-dial
telephone.
You can change which direct-dial telephone a telephone is assigned to, or
assign it no direct-dial telephone.
1. Place the programming template over the appropriate buttons of the
programming telephone.
Press ≤••¤flfl‹››.
2.
Press ¤‹fl›fl (the default System Coordinator password).
3.
Press ≠ at Terminals&Sets.
4.
5. Enter the internal number of the telephone you want to program and
press ≠. The display shows Capabilities.
Press ≠.
6.
Press ' until the display shows D-Dial.
7.
Press CHANGE to select either Set1 or None.
8.
Compact ICS 7.1 System Coordinator Guide N0130955 01