172 / Programming Hunt Groups
Press ® to exit or ' to continue programming.
8.
Setting the name
This setting allows you to program the Hunt Group name, such as
SERVICE or SALES. The name can be up to seven characters in length.
This name becomes the CLID display name when the DN is called.
At Hunt groups, press ≠. The display shows Show group.
1.
2.
Enter the Hunt Group number you want to program (1-6) or press
' to scroll through the groups.
Press ≠. The display shows Member DNs:.
3.
Press '. The display shows Name:.
4.
Press CHANGE.
5.
6.
Using the dialpad, enter the name of the Hunt Group.
Press ' to store the name.
7.
Press ® to exit or ' to continue programming.
8.
Allowing/disallowing an auxiliary ringer
This setting allows you to allow/disallow an external ringer to sound when
a call comes in for a specific hunt group. If you allow this service, you must
have an auxiliary ringer properly installed on your system. Refer to ''Using
an auxiliary ringer'' on page 224.
At Hunt groups, press ≠. The display shows Show group.
1.
2.
Enter the Hunt Group number you want to program (1-6) or press
' to scroll through the groups.
Press ≠. The display shows Member DNs:.
3.
Press ' until the display shows Aux. Ringer:.
4.
Press CHANGE to choose Y (yes) to turn the ringer on or N (No) to
5.
disallow an auxiliary ringer.
Press ® to exit or ' to continue programming.
6.
Compact ICS 7.1 System Coordinator Guide
N0130955 01