Using A Line Pool To Make A Call; Programming A Memory Button With A Line Pool Feature Code - Nortel Compact ICS 7.1 Coordinator Manual

74 / Making calls
code is used in the same way as the line pool access code, but you may need
to dial fewer following numbers if the route is set up to automatically dial
part of the call number.
Your installer or customer service representative programs the line pool
access codes and destination codes and gives each telephone access to the
relevant line pools.
Everyone in the office should have a list of the line pool access codes and
destination codes for the line pools their telephones can use.

Using a line pool to make a call

≤fl›
1. Press
2. Dial a line pool access code or destination code.
3. Dial the number you are calling.
If you have a free internal line, you can make a call using a line pool
without entering the feature code first.
1. Select an internal line (intercom).
2. Enter a line pool access code or destination code.
3. Dial the number you are calling.
Tip -
use Ring Again at the busy tone. You are notified when
a line in the line pool becomes available. See ''Using
Ring Again'' on page 79.
Programming a memory button with a line pool
feature code
When you program a button with the line pool feature code, you must enter
a line pool access code after the feature code. The programmed line pool
button accesses a specific line pool, not the line pool feature. See
''Programming feature buttons'' on page 147 for more information.
Compact ICS 7.1 System Coordinator Guide
.
If no lines are available in the line pool, you can
N0130955 01