Table of Contents
Advertisement
160 / Using User Preferences
The display shows
connected at that internal number.
You cannot make changes if the model is
3. Press
User Preferences programming is available under the heading
Changing button programming
1. Press
the number of buttons on the telephone. An example is
shown in Displays at the end of this section.
If the telephone has a KIM module, you can press
see the buttons on the module.
2. Press
telephone. Refer to Default button assignments on page
150 for button number mapping for each type telephone.
3. Use the display buttons to change the programming for a
button.
The display buttons used in button programming.
Modular ICS 7.1 System Coordinator Guide
to move through all the subheadings in
.
.
at
to move through all the buttons on the
Moves you out of a setting without making any changes to
it.
Erases the button.
Programs the button as an autodial number for an internal
or an external number. If it is an external autodial number,
you must choose a line, line pool, or the routing table for the
call to use.
Used when you are setting up an external autodial number.
Press
until you see the type of line or pool you want
the number to use.
Press to store a feature code on the button.
if no telephone is
.
. The display shows
N0130946 01
to
Advertisement
Table of Contents
