Moving Members Of A Group - Nortel Compact ICS 7.1 Coordinator Manual

Consult your customer service representative to determine your Hunt
Group number range.
Note: Your system DN must be at least three digits long to allow Hunt
Groups.
You need the programming template found at the front of this guide. See
''Getting started with Norstar'' on page 15 for more information.
Press ≤••¤flfl‹››. The display shows Password:.
1.
Press ¤‹fl›fl (the default System Coordinator password).
2.
The display shows Terminals&Sets.
Press ' until the display shows System prgrming.
3.
Press ≠. The display shows Hunt groups.
4.
Press ≠. The display shows Show group.
5.
6. Enter the Hunt Group number you want to program (1-6).
Press ≠. The display shows Member DNs:.
7.
Press ≠. The display shows the members for that group.
8.
Press ADD to add a member or press REMOVE to remove a member from
9.
the group.
10. Press ® to exit or ' to continue programming.

Moving members of a group

Member order within a Hunt Group is important. The member order
determines how a call is routed through a Hunt Group.
You need the programming template found at the front of this guide. See
''Getting started with Norstar'' on page 15 for more information.
At Hunt groups, press ≠. The display shows Show group.
1.
2. Enter the Hunt Group number you want to program (1-6) or press
' to scroll through the groups.
Press ≠. The display shows Member DNs:.
3.
Press ≠. The display shows the members for that group.
4.
N0130955 01
Programming Hunt Groups / 167
Compact ICS 7.1 System Coordinator Guide