Nortel Compact ICS 7.1 Coordinator Manual page 49

Customizing the eKIM
You can move external line appearances, target line appearances, or hunt
group appearances onto the eKIM by using ≤•°⁄. See ''Moving
line buttons'' on page 156.
Any of the buttons on the eKIM that do not support lines can be
programmed to auto dial internal or external numbers. You also still can
program features directly onto eKIM buttons. Refer to ''Time savers for
making calls'' on page 95 and ''Customizing your telephone'' on page 145
for information about programming memory buttons.
eKIM button programming for CAP
Any line appearances and target line appearances assigned to the 7316E,
which overflow to the eKIM, must be assigned by your installer. You can,
however, use the Coordinator password to assign the telephone to the hunt
groups for which you want to provide an appearance. Refer to
''Programming Hunt Groups'' on page 165 for information about
programming hunt group appearances.
Designating features or autodial numbers to the eKIM buttons, can be
programmed using the Button progrmng, which is found under User
Preferences under Terminals&Sets.
1. Place the programming overlay over the appropriate buttons on your
two-line-display telephone.
Press ≤••¤flfl‹››.
2.
Press ¤‹fl›fl (the default System Coordinator password).
3.
Terminals&Sets displays.
Press ≠. Show set: displays.
4.
5. Enter the DN number of the 7316E which is attached to the eKIM you
want to program, then press OK.
Press ≠. Capabilities displays.
6.
Press ' two times until User preferences displays.
7.
Press ≠. Model displays (7316E+<n>KIM).
8.
Press '. Button progrming displays.
9.
N0130955 01
Answering calls / 49
Compact ICS 7.1 System Coordinator Guide