Changing Handsfree For A Telephone - Nortel Compact ICS 7.1 Coordinator Manual

66 / Answering calls

Changing handsfree for a telephone

You can program the type of handsfree used with each telephone.
1. Place the programming overlay over the appropriate buttons on your
two-line-display telephone.
Press ≤••¤flfl‹››.
2.
¤‹fl›fl
3. Press
Press ≠ and enter the internal number of the telephone you
4.
want to program.
Press ≠ twice.
5.
Press ' three times.
6.
Choose a setting at Handsfree: using the CHANGE button.
7.
There are three ways to set handsfree for an individual telephone:
Handsfree:None
Handsfree:Auto
Handsfree:Std
Need Handsfree
For other displays, see ''Common feature displays'' on page 243.
Both Auto and standard handsfree allow you to use a headset with a system
digital phone.
A handsfree/mute button is automatically assigned to a legacy Norstar
telephone that is programmed with handsfree and is always located in the
lower right-hand corner of the numeric dialpad. For 7208 and 7316 digital
Compact ICS 7.1 System Coordinator Guide
(the default System Coordinator password).
Handsfree is not available to the telephone.
CHANGE
You can make or answer a call without having to
pick up the handset or press the button labeled
CHANGE
handsfree/mute. The internal microphone and
speaker of the telephone turn on automatically
when you press a line or intercom button to make
or answer a call.
A standard version of handsfree described ''Using
handsfree/mute'' on page 62. Not available for
CHANGE
7316E digital phones.
This prompt appears if you attempt to use
handsfree or headset and the telephone not been
configured with Auto under Handsfree.
N0130955 01