Programming The Fastrad - Nortel FastRad Installation Manual

10
Programming
the FastRAD
Programming Field
Password
System ID
Auto-answer line number
Alarm reporting line number
Local baud rate
Auto report alarms
Alarm number 1
Alarm number 2
Retry delay
Number of retries
Alarm reporting baud rate
Alarm reporting parity
Auto-answer
Answer delay
Table 2 – Programming parameters and default values
FastRAD Installation Guide
Before you start, make sure you have completed the FastRAD
Programming Record found at the end of this guide. This
record must include the System ID, Auto-answer line number
and Alarm reporting line number.
Table 2 shows the different programming parameters and their
default values. If your programming information does not
specify a value for one of the fields, assign it to the default
value.
Note: You must program the Required fields for the FastRAD to
operate. Also program any Optional fields that apply to your
system. Auto-answer should be set to ON if unassisted remote
access to the FastRAD is desired.
Range
8 to 10 digits
Up to 10 digits
1 - 999
1 - 999
300/1200/2400/4800/
9600/19200
ON, OFF
up to 16 digits
up to 16 digits
1 - 99 minutes
0 - 9
Low/Medium/High
None/Odd/Even
ON, OFF
6 to 60 seconds
Required / Optional
Required
Optional
Required for auto-answering
Required for alarm reporting
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Default
none
blank
Line 001
Line 001
9600
OFF
blank
blank
15 minutes
5
High
None
OFF
18 seconds