Table of Contents
Advertisement
Teledyne API Model T360/T360M Operation Manual
Table 4-3:
List of Warning Messages
MESSAGE
ANALOG CAL WARNING
BENCH TEMP WARNING
BOX TEMP WARNING
CANNOT DYN SPAN
CANNOT DYN ZERO
CONC ALRM1 WARNING
CONC ALRM2 WARNING
CONFIG INITIALIZED
DATA INITIALIZED
O2 CELL TEMP WARN
PHOTO TEMP WARNING
REAR BOARD NOT DET
RELAY BOARD WARN
SAMPLE FLOW WARN
SAMPLE PRESS WARN
SAMPLE TEMP WARN
SOURCE WARNING
SYSTEM RESET
WHEEL TEMP WARNING
07272B DCN6552
MEANING
The instrument's A/D circuitry or one of its analog outputs is not calibrated.
The Temperature of the optical bench is outside the specified limits.
Remote span calibration failed while the dynamic span feature was set to turned on
Remote zero calibration failed while the dynamic zero feature was set to turned on
Configuration was reset to factory defaults or was erased.
Concentration alarm 1 is enabled and the measured CO
Concentration alarm 2 is enabled and the measured CO
Configuration storage was reset to factory configuration or erased.
DAS data storage was erased.
O
sensor cell temperature outside of warning limits.
2
The temperature of the IR photometer is outside the specified limits.
The CPU is unable to communicate with the motherboard.
The firmware is unable to communicate with the relay board.
The flow rate of the sample gas is outside the specified limits.
Sample gas pressure outside of
The temperature of the sample gas is outside the specified limits.
The IR source may be faulty.
The computer was rebooted.
The Gas Filter Correlation wheel temperature is outside the specified limits.
Operating Instructions
level is ≥ the set point.
2
level is ≥ the set point.
2
operational parameters.
71
Advertisement
Table of Contents
