Com Port Testing - Teledyne T360 Operation Manual

Operating Instructions

4.11.11. COM Port Testing

Select which
COM port to test.
128
The serial ports can be tested for correct connection and output in the com menu.
This test sends a string of 256 'w' characters to the selected COM port. While
the test is running, the red LED on the rear panel of the analyzer should flicker.
To initiate the test press the following touchscreen button sequence.
SAMPLE* RANGE = 500.000 PPM
< TST TST > CAL
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG
SETUP X.X COMMUNICATIONS MENU
ID INET COM1
SETUP X.X COM1 MODE:0
SET> EDIT
SETUP X.X COM1 BAUD RATE:19200
<SET SET> EDIT
SETUP X.X COM1 : TEST PORT
<SET TEST
SETUP X.X TRANSMITTING TO COM1
<SET TEST
Teledyne API Model T360/T360M Operation Manual
CO2 =X.XXX
SETUP
MORE EXIT
EXIT
COM2 EXIT
EXIT
EXIT
EXIT
EXIT
Test runs
automatically
EXIT returns to
COMM menu
07272B DCN6552