Encoder; Connection; Parameterization - Honeywell EK280 Applications Manual

EK280
− Enter the pulse generator's cp value, by moving the cursor to the digits using the  or  arrow keys
and update it using the  or  arrow keys.
− Press the ENTER key to confirm the set value. It is possible to abort the entry by pressing the ESC
key.
− Close the administration lock of the EK280.
Setting the counter value
− If necessary, the meter reading of the gas meter can be set as the starting value for the volume at
measurement conditions Vm. The procedure is described in  chapter 2.4.4.

4.3 Encoder

4.3.1 Connection

Danger!
For EK280 with internal power supply, the mains voltage must be switched off before
opening the housing, ensure it is not turned back on and verify that there is no voltage.
(Namur or SCR)
− Connect the gas meter encoder to terminal "DE1" of the EK280.
− Release the input 1 (terminal "DE1") calibration seals.

4.3.2 Parameterization

i
When using other parameter settings for the encoder (e.g. timings) in the EK280 then the battery
life may become shorter.
Parameterization can be carried out here using the EK280 keypad.
Alternatively, parameterization can be carried out using the enSuite program. The paths which are described
below can be found in enSuite under
Application Manual
DE1
+ -
+ -
Encoder
"Parameterize online" > "Parameters".
25