Honeywell EK280 Applications Manual page 125

EK280
Value
APN Username "UName"
APN Password "PwAPN"
GPRS Port Address "Port"
i
If you fail to input an Access Point Name (APN), the APN that is saved on the SIM is used. Since
this is usually a public APN (no access to a VPN) and since a dynamic IP address is allocated
when a GPRS session with a public APN is set up, the TCP server function cannot be used! This
is because a static IP address would be needed for this purpose. In such a case, the modem
could only be used as TCP client.
Attention: Without the input of an APN there is the risk that unspecified costs may be incurred,
as with every set up through a GPRS provider and based on a corresponding tariff a minimum
data volume (e.g., 10 or 100 kB) will be billed!
− Press the "Transfer changes to
− If required (i.e. with the aid of the enSuite user list) two further addresses for a "Domain Name
System" can be entered in addresses 3:0794.0 and 3:0795.0. This is however not essential.
c) Set individual parameters (Integra M2106 only or ECM-GW120 with "ComTCPserv")
− On this GPRS modem the VPN access data are not parameterized in the EK280, but in the GPRS
modem refer to  chapter
(p. 124).
d) Setting time window for potential data retrievals
In the base configuration now displayed you can define time windows, during which data can be cyclically
retrieved from the EK280 via the modem. Time windows 5 and 6 are reserved for EK280 operation with an
FE260, and generally only time window 5 is used. Redundant time windows can be deactivated by setting
the time window start and end to the same value.
− In the top of the device window open the path "Parameters" > "Interfaces" by clicking on the relevant
plus signs, and then select
− For call window 5, set the start to "00:00" and the end to "23:59" and then select the "Transfer
changes to device" icon at the top of the enSuite window.
− Finally, turn the FE260 power supply back on.
− Wait for around a minute for the EK280 to detect the FE260.
− Check whether appropriate bars indicating the signal level for the external modem ("e") appear on
the main display of the EK280.
Application Manual
These values vary according to the SIM card and VPN
(Virtual Private Network) in use. The values to be entered
can normally be obtained from your IT department or SIM
card provider.
"Port" means the TCP port no. of the retrieval system in
use.
device" icon at the top of the enSuite window.
7.4.6.2 Parameterization of the GPRS/TCPserv modems in the FE260
"Call time windows".
Input
123