Connection Of Outputs; Lf Pulse Output (Low-Frequency); Parameterization - Honeywell EK280 Applications Manual

EK280

6.1 Connection of outputs

Danger!
For EK280 with internal power supply, the mains voltage must be switched off before
opening the housing, ensure it is not turned back on and verify that there is no voltage.
− Connect the device to one of the desired digital outputs (terminals "DA1" to "DA4") on the EK280.

6.2 LF pulse output (low-frequency)

Each of the outputs 1 to 4 (terminals DA1 to DA4) can be programmed as a low-frequency pulse output.

6.2.1 Parameterization

Parameterization is carried out via the keyboard on the EK280.
Alternatively, parametrization can be carried out using the enSuite program. The paths which are
subsequently described can be found in enSuite under
a) Setting up the output mode:
Move the cursor to register "Serv."and along the following path to the mode for the corresponding
−
output "Md.O1" to "Md.O4":
Serv.  Outputs
Serv. Outputs

Serv.  Outputs
Serv.  Outputs
i
The low-frequency pulse output of the EK280 can be operated with active or inactive logic.
The output mode must be programmed accordingly for this purpose (see below).
− Press the ENTER key. ⇒ The actual parameterized value flashes.
Application Manual
+ -
DA1
+ -
DE1
Downstream device,
e.g. DL220
 Output 1  Md.O1
Output 2 Md.O2
 
 Output 3  Md.O3
 Output 4  Md.O4
"Parameterize online" > "Parameters".
42