EK280
7.4.10 FE260 with Ethernet Adapter
i
ATTENTION! This description is only valid for EC280 as of V2.40.
For versions smaller than V2.32, please use the Application Manual 2015-1.
Modem adapter board 73016717 V1.2
with attached LAN cable 04115524
This interface card is used as an interface with your Ethernet LAN.
Prerequisites for process described below:
−
The FE260 is connected as described in chapter
it must not be live.
7.4.10.1 Parameterization of the EK280 for operation with an FE260/Ethernet
i
For parameterization of the EK280 you need a connection cable for the optical interface as well
as the enSuite program. enSuite can be downloaded free of charge from the Honeywell website
in the "Software Downloads" section:
www.elster-instromet.com/en/software-downloads
a)
Closing the time windows
In order that the parameterization works correctly the time windows 5 and 6 must be closed. Proceed as
described in chapter
7.3.2.1
b)
Send parameter file
−
Send the following parameter file to the EK280 ( chapter
EK280_xvx. - FE260 & int. Ethernet adapter (*)
The "x" stands for the version of software on the device, e.g. "2v2".
33
Application Manual
Fig. 15: INSYS Ethernet adapter in the FE260
(p. 101).
INSYS Ethernet module
04407090
7.4.1 FE260 connection
3.6 Send parameter
33
141
(p. ). It is connected but
file, p. 21):