Securing The Outputs - Honeywell EK280 Applications Manual

EK280
Fig. 4

6.11 Securing the outputs

Each output can be individually secured against manipulation by means of a terminal cover and also be
sealed with an adhesive seal if required. Terminal covers are delivered in the bag of accessories. If
necessary, screw into position via the terminals connected and then stick a seal onto the fixing screw (see
below).
Fig. 5
i
Sealing for securing pulse inputs and outputs is subject to national law ( WELMEC 11.1,
chapter 2.7.1).
Depending on the legal situation in the country of use, seals from a group of people set out in
law or from meter operators must be used.
If devices are delivered with connected input and/or output cables then seals with the
manufacturer's symbol are applied at the plant. If necessary, these can be substituted on site.
Application Manual
Switch for electrical isolation
Output "DA3" is electrically isolated
(the slider on the switch is up)
Outputs "DA1", "DA2", "DA4" are not
electrically isolated (The sliders on the
switches are down)
Output "DA1" is protected with a terminal cover.
An adhesive label can now be adhered over the
screw for sealing.
57