Honeywell EK280 Applications Manual page 152

EK280
7.5.2.3 EK280 jumpers
X6: No jumper
or one jumper on the pins located
near the terminals
7.5.2.4 Parametrization of the EK280
i
For parameterization of the EK280 you need a connection cable for the optical interface as well
as the enSuite program. enSuite can be downloaded free of charge from the Honeywell website
in the "Software Downloads" section:
www.elster-instromet.com/en/software-downloads
a) Closing the time windows
In order that the parameterization works correctly the time windows 5 and 6 must be closed. To do this:
− Connect a PC or laptop with enSuite installed to the EK280 optical interface using the connection
cable.
− Start enSuite and set up the communication link to the EK280.
( chapter 3.1 Setting up the communication link to the EK280 via optical
Select "Navigation" on the left-hand side and then
−
navigation window.
− In the top of the device window open the path "Parameters" > "Interfaces" by clicking on the relevant
plus signs, and then select
− In call windows 5 and 6 set start and end to the same value for each one and then select the
"Transfer changes to device" icon at the top of the enSuite window.
− Then wait a minute, for any communications activity in progress on the EK280 to be safely stopped.
b) Send parameter file
− Send the following parameter file to the EK280 ( chapter
−
EK280_xvx. - ext. MTL5051-converter (RS-232) (*)
36 The "x" stands for the version of software on the device, e.g. "2v2".
The star * stands for a small letter which indicates the version of the file, e.g. "a".
Application Manual
X5: two jumpers
on the pins further
away from the terminals
"Parameterize
"Call time windows".
36
interface, p. 19)
online" at the bottom of the
3.6 Send parameter file, p. 21):
150