Honeywell EK280 Applications Manual page 105

EK280
CAUTION! 230 V alternating voltage! Risk to life!
Parameterization of the modem in the EM260 may only be carried out by personnel suitably
qualified.
i
For later parameterization of an EM260 for operation with an EK280, you need the USB
parameterization cable ref. no. 73020481 and the program ModemIni V3.50 or later; you may
request this from Honeywell free of charge.
For parameterization of the EM260 proceed as follows:
− Make sure that the EM260 is initially not connected to a power supply.
− In the EM260, insert jumper J1 in the lowest position ( Operating Instructions for the EM260,
chapter 10 "Jumper").
− Connect a USB interface of your computer with the aid of the USB parameterization cable 73020481
to the modem parameterization interface ST7 on the EM260 board (blue, 2x5 pole pin connector
strip on the left next to the communication module).
− On your computer, start the modem parameterization program "ModemIni" (Version 3.50 or later).
− Switch on the power to the EM260.
CAUTION! 230 V alternating voltage! Risk to life!
− Using ModemIni, effect the following settings:
o terminal device: EK280
o Modem box: EM260
o Modem module: Analogue PSTN data modem
o PC interface: COMx (the COM interface, to which the parameterization cable is connected)
Application Manual 103