Send Parameter File - Honeywell EK280 Applications Manual

EK280
− The device identifier is now displayed at the bottom of the navigation window. If no command list is
displayed underneath, click on the arrow next to the device identifier.
− In the lower part of the navigation window, press
− Click on the plus sign next to "Parameter" at the top of the navigation window, to expand the
parameter tree.
− In this parameter tree you can open parameter pages, to update parameters or drill down to open
more parameter pages.

3.6 Send parameter file

Prerequisite:
A communication link between enSuite and the EK280 via optical interface, modem or network
(TCP/IP) has been set up ( chapters
− Select "Navigation" on the left-hand side.
− Click on the plus sign next to "Connections" in the newly-opened navigation window.
− Click on the entry beginning with the serial number of the connected device.
− The device identifier is now displayed at the bottom of the navigation window. If no command list is
displayed underneath, click on the arrow next to the device identifier.
− Select "Send parameter
− Click "Open..." in the top right.
In the dialog box
−
then press "OK".
i
In enSuite from version 2.7 onwards, the name and issue (in brackets) of the parameter file are
both displayed. The file extension ".wpp" is not displayed.
i
If needed, any arbitrary wpp file can be selected with the
that this manually selected wpp file is suitable for the EK280 software version.
− Click on "Start" in the bottom right and wait until the file has been successfully sent.
In the center of the window, you will see the number of rows that have been sent along with
i
the number of rows containing errors (if applicable)
You must check in such cases whether the necessary locks are open and/or whether the file
used is suitable for the device version. Contact the Honeywell hotline ( EK280 manual) is
necessary.
− To begin another task, click again on "Navigation" on the left-hand side.
Application Manual
3.1
file".
select the corresponding directory and the parameter file and
"Select WPP file"
"Parameterize online"
to 3.3).
"File system..." button. Make sure
21