Honeywell EK280 Applications Manual page 121

EK280
Integra M2106+
ECM-GW120:
ECM-2G-UG350:
ECM-3G-UU270:
i
When the "...ECM-3G-UU270 (GPRS)
generally logs into the 2G network (GPRS). As such, the higher data rates which are possible in
the 3G network (UMTS) cannot be used.
When using the parameter file
the 3G network (UMTS), if it is locally available. The modem only uses the 2G network (GPRS) if
no 3G network is available locally. However beware: In the German 3G networks (Telekom,
Vodafone, O2), the CSD service (Circuit Switched Data) is not supported!!!!
Summary
If you want to use the CSD data transmission in Germany, you must also operate the modem in
the 2G network! In other countries, you may need to clarify the circumstances with your network
provider!
− For the following customized settings and tests required, press "Navigation" on the left-hand side
and then "Parameterize
i
All the values listed in enSuite under "Parameters" can be found on the "Serv." display tab of the
EK280 under the same path.
c) Setting time window for potential data retrievals
In the base configuration now displayed you can define time windows, during which data can be cyclically
retrieved from the EK280 via the modem. Time windows 5 and 6 are reserved for EK280 operation with an
FE260, and generally only time window 5 is used. Redundant time windows can be deactivated by setting
the time window start and end to the same value.
− In the top of the device window open the path "Parameters" > "Interfaces" by clicking on the relevant
plus signs, and then select
− For call window 5, set the start to "00:00" and the end to "23:59" and then select the "Transfer
changes to device" icon at the top of the enSuite window.
7.4.5.2 Checking GSM field strength
Before starting a data transfer via the modem, you must ensure that there is adequate reception field
strength.
− Finally, turn the FE260 power supply back on.
− Wait for around a minute for the EK280 to detect the FE260.
The "x" stands for the device software version, e.g. "2v5".
24
The star * stands for a small letter which indicates the version of the file, e.g. "a".
 next infoblock
25
Application Manual
EK280_xvx.. - FE260 & M2106 – GSM (*)
EK280_xvx.. - FE260 & ECM-GW120 - WipSoft (GSM) (*
EK280_xvx.. - FE260 & ECM-2G-UG350 (GPRS) (*)
EK280_xvx.. - FE260 & ECM-3G-UU270 (GPRS) (*)
or EK280_xvx.. - FE260 & ECM-3G-UU270 (UMTS) (*)
(*)" parameter file is used, the ECM-3G-UU270 modem
"...ECM-3G-UU270 (UMTS)
online" at the bottom of the navigation window.
"Call time windows".
24
24
)
24
24 , 25
24 , 25
(*)" the modem preferably logs into
119