Parameterizing By Keyboard - Honeywell EK280 Applications Manual

EK280

6.5.1 Parameterizing by keyboard

i
The use of enSuite parameterizing software is strongly recommended for parameterizing a
status output (see below).
Parameterization with the keyboard on the EK280 is described below.
a) Setting up the output mode:
− Move the cursor to the tab "Serv." and subsequently via the following path to the mode for the
corresponding output "Md.O1" to "Md.O4":
Serv. Outputs

Serv.  Outputs
Serv.  Outputs
Serv.  Outputs
i
The low-frequency event outputs of the EK280 can be operated with active or inactive
logic.(as a make contact or break contact). The output mode must be programmed accordingly
for this purpose ( below).
− Press the ENTER key. ⇒ The set value flashes.
− Press down one of the arrow keys  and/or  press repeatedly until the text „Event(C)"
„Event(O)" flashes.
3
Whereby:
"(C)" = closer:
"(O)" = opener:
− Press the ENTER key to confirm the set value. It is possible to abort the entry by pressing the ESC
key.
b) Setting the status display for the output:
− In the corresponding output menu press the  key repeatedly until "SpO1", "SpO2", "SpO3", or
"SpO4" is displayed.
− Press the ENTER key. ⇒ The set value flashes.
− Move the cursor with the arrow keys  or  to the digits and change these with the arrow keys  or
 to a value that is specified in the table.
For software versions prior to V2.50,
2
For software versions prior to V2.50,
3
Application Manual
Output 1 Md.O1
 
 Output 2  Md.O2
 Output 3  Md.O3
 Output 4  Md.O4
When the message is activated, the output is switched on (closed).
When the message is activated, the output is switched off (opened).
(event +) is displayed.
"Event+"
"Event-" (event -) is displayed.
50
or
2