EK280
−
Set up the communication link between the PC or laptop and the modem as described in 0 "Modem
Application ComFTP – Operating Instructions".
−
Parameterize the ComFTP according to your requirements as described in 0 "Modem Application
ComFTP – Operating Instructions".
−
Remove the communication link between the PC / laptop and the Modem again.
−
Disconnect the parameterizing cable from the modem assembly.
−
Refit the "mode" jumper on the FE260 modem board in the "operation" position.
7.4.7.9 EK280 data transfer activation
−
Set up a communication link via the optical interface between enSuite and the EK280 again.
( chapter
3.1 Setting up the communication link to the EK280 via optical
−
Select "Navigation" on the left-hand side and then
navigation window.
−
In the top of the device window open the path "Parameters" > "Interfaces" by clicking on the relevant
plus signs, and then select
−
For call window 5 set the start to "00:00" and the end to "23:59" and then select the "Transfer
changes to device" icon at the top of the enSuite window.
−
Wait for around a minute for the EK280 to detect the FE260.
7.4.7.10 Checking GSM field strength
Move the cursor to the "Serv." tab in the EK280's display, then to
−
Interfaces > Terminal interface > Hardware Config. >
−
Press the
ENTER
−
Press the
ENTER
−
Move the cursor to the "Serv." tab in the EK280's display, then to
Interfaces > Terminal interface > GSM & GPRS > GSM.L
−
Wait a few seconds until the field strength percentage is displayed under GSM.L.
i
With a field strength below 50% data transfer issues may be encountered. Adjusting the antenna
position can improve field strength in most cases.
−
Move the cursor to the "Serv." tab in the EK280's display, then to
Interfaces > Terminal interface > Hardware Config. >
−
Press the
ENTER
−
Press the
ENTER
7.4.7.11 Monitoring data transfer to the FTP server
Now you can check the data transfer to the FTP server using a suitable FTP client (i.e. "Filezilla"). Data
should now be automatically transferred at the intervals programmed in the ComFTP from the volume
conversion device to the server.
Application Manual
"Call time
windows".
key and using the keypad set the value to
key to save the input.
key and using the keypad set the value to "transparent".
key to save the input.
interface, p. 19)
"Parameterize
online" at the bottom of the
MdxS2.
"GSM
Wavecom".
MdxS2.
136