Plc Data Output Via V24 On Mmc102/103 - Siemens SINUMERIK FM-NC Installation And Startup Manual

11 Data Backup
11.3 Data backup via MMC 102/103
11.3.4 PLC data output via V.24 on MMC102/103
PLC data
Procedure
11.3.5 Output of MMC data via V.24 on MMC102/103
Display MD
Definitions
11-262
The PLC data must be saved in an archive file before this file can be output via
V.24.
1. Press the Series start-up softkey
2. Select only PLC
3. Press the Archive softkey
4. The display changes and the task log appears. The file PLC.ARC is
created.
5. When the "task finished" message appears, press Data out.
6. In the directory, select Archive\PLC.ARC and press Interface.
7. V.24 setting with archive format: Set binary format (PC format), close with
ok.
8. Press V24 softkey and confirm with OK softkey; the PLC data are output.
On the MMC, the display machine data (MD 9000, ...) must be saved via the file
functions (start-up). These machine data are stored in RAM with the
MMC102/103. The data are stored in the directory Diagnosis\MachDat/Opera-
torPanel. The file name specified when the data were saved appears in the
directory.
To output the display machine data, position the cursor on the desired file and
press the V24 softkey, followed by OK. The display machine data can be output
in punched-tape format.
The definitions directory contains the definitions for the macros and global user
data. These include:
S
SMAC.DEF (%_N_SMAC_DEF)
S
MMAC.DEF (%_N_MMAC_DEF)
S
UMAC.DEF (%_N_UMAC_DEF)
S
SDUD.DEF (%_N_SGUD_DEF)
S
MGUD.DEF (%_N_MGUD_DEF)
S
UGUD.DEF (%_N_UGUD_DEF)
The definitions can be output via V.24.
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
 Siemens AG 2000 All Rights Reserved
03.96